Charged Nylon Membrane and NaOH Transfer Solution:

1. Run glyoxal gel as usual. Begin set up for Northern transfer prior to end of electrophoresis. Use positively charge nylon membrane instead of nitrocellulose.
• Do not treat gel with 50 mM NaOH.
2. Transfer RNA's by capillary action to charged nylon membrane essentially according to the method for Northern Blot transfer to nitrocellulose membrane.
3. Use freshly prepared 10 mM NaOH as the transfer solution, instead of 20X SSC, when using charged nylon. Wet charged nylon in ddH2O, and soak in 10 mM NaOH for 5 minutes prior to transfer.
4. After transfer, soak filter in 2 X SSC + 0.1% SDS for 2 minutes at room temperature. Dry at room temperature. Store dry at 4℃ until pre-hybridization.
• It is not necessary to bake, or UV-crosslink, RNA to membrane.
• It is not necessary to treat RNA with Tris buffer at 65℃ to remove glyoxal.

Unmodified Nylon Membrane and SSC Transfer Solution:

1. UV-cross link RNA's to uncharged nylon blot. Alternatively, bake for 1-2 hours at 70℃ in vacuum oven. Blot may be stored at RT under vacuum.
To UV cross - link :
A. Rinse blot in 2X SSC for 5 minutes at RT.
B. Place membrane on filter paper to blot away excess liquid.
C. Place DNA side up in cross-linker with filter paper underneath.
D. Select and start "auto cross-linking".
E. Air dry membrane at RT. Can store wrapped in foil under vacuum at RT.
2. Remove glyoxal from RNA's by washing filter with 20 mM Tris-C1, pH 8.0 at 65℃ for 15 minutes. For this, float tray in H₂O bath at 65℃.

Stripping Nylon Membranes

1. Place membrane in tray with TE, pH 8 at 25℃. Keep membrane moist (wrapped tightly in plastic)
to prevent drying after first probing. Use survey meter to estimate bound radioactivity.
2. Prepare 1 L of 10 mM Tris-HCl, pH 9, 1 mM EDTA as follows:

Optional: SDS can be added to 0.01% (1/1000 of 10% SDS).
3. Bring 1 L TE to a boil. Turn off heat. Dip membrane into hot TE and submerge for 1 minute.
4. Transfer membrane back to tray with TE. Use survey meter to estimate bound radioactivity. Wrap
membrane in plastic and expose to film to confirm removal of probe.
5. Reprobe after repeating pre-hybridization.

上一页  [1] [2]